Product Code: Prototyping Shield
Availability: In Stock
₹110.00

Description

Works with the Uno! This prototyping shield is the best out there (well, we think so, at least). It works with UNO, NG, Diecimila and Duemilanove Arduinos.. Specifications It has a nice standard 0.1"x0.1" prototying grid with big pads A IC pattern for adding DIP ICs up to 20 pins Power rails down the middle and sides A reset button and an extra general use button 2 3mm general use LEDs, red and green, as well as 2 matching resistors The ICSP header is up top if you like to upload to your Arduino using a programmer A surface-mount chip area for up to 14 SOIC size parts Compatible with either tiny breadboards or 'standard' breadboards with the rails removed. Every pin is brought out, including the new 3V and Reset header pins 2 0.1uF capacitors on either side for extra power stability - For more information, visit http://sunrobotics.co.in/index.php?main_page=index&cPath=2

specification

  • Screen Size: 64x48 pixels (0.66” Across)
  • Operating Voltage: 3.3V
  • Driver IC: SSD1306
  • Interface: IIC(I2C)
  • IIC Address: 0x3C or 0x3D


Write a review

Note: HTML is not translated!